This week we began our actual screw tip part designs. We were left alone to create our own separate screw tip parts. Below is the end results of the two that we made. We also created a simulation of what the screwdrivers would look like if we attached the tips onto them. The result of that can also be found below.
0 Comments
We were told to create a separate part that we could detach and attach to our screwdriver at will. We were also required to modify our screwdriver to fit the tips since everyone in the class was to make one that would fit any screwdriver in our class. Below is the final product of the open tip screwdriver.
This week we began our fourth assignment on creating a custom screwdriver design. We were to research some designs which we liked and thought we could improve or incorporate into our designs. We also created sketches this week and are hoping to begin modeling next week. Here is the research and the related designs I created this week. The design I've narrowed myself down to creating is the "Drawer's Delight" that I came up with. I am still in the process of creating the refined sketch page for it so showcase but I should be finished by the end of Tuesday.
This week we created a layout page for our replicas and their measurements. Since I finished earlier in the week I decided to create some design drawings for fun on other subjects. The fly face and the armored suit are just some sketches I put together in a few days. ![]()
|
Ashborn BinapalIm a Grade 11 student in training on animation techniques and sketching. Archives
June 2016
Categories |